|
Bonded
Recreational Surfaces
ITF
Performance Testing
 |
Slip Resistance - (4mm System)
Dry - 106
Wet - 67
ITF Recommended Range – 60 - 110
Surface Pace *
Dry - medium*
Traction Co-efficient
Dry - 1.20
Wet - 0.92
ITF Recommended Range - 0.6 – 1.5
|
Installation
Sub-base:
Consolidated crushed stone with 2-course dense bitumen macadam receiving layer
preferred, or concrete indoors.
Laying method:
Acrylic Resurfacer applied over sub-base to prevent any upward moisture migration.
A layer of adhesive is applied, onto which the Shock pad is adhered. A Porefiller
layer is laid, over which the three layers of aggregated acrylic colour is
squeegeed on.
Laying conditions:
Must be dry with a minimum 10ºC. Indoors, ventilation and/or de-humidification
may be necessary.
Surface finish:
Final colour coating squeegee applied. Play-lines painted onto the surface.
Surface available in a choice of
colours or a combination of any two colours.
* Please note the Surface pace can
be adapted to suit your requirements during the manufacturing
process.
Maintenance
Little maintenance is required,
although the surface should be kept clean and free
of dust and debris. Washing the surface at least
once a year, or more regularly if required, is recommended.
Loose-Lay
Cushioned Acrylic Recreatonal Surface
 ITF
Performance Testing
Slip Resistance
Dry - 104
Wet - 72
ITF Recommended Range – 60 - 110
* Surface Pace
Dry - Slow / medium
Traction Co-efficient
Dry - 1.20
Wet - 1.00
Installation
Sub-base:
A level sub-base is required which should be dry and
clean from obstruction prior to laying.
Laying method:
The required number of rolls of rubber shock pad are
rolled out. A layer of Porefiller is applied on top
to ensure the acrylic colour does not seep into the
shock pad. The three layers of aggregated acrylic
colour is squeegee applied, over which the lines are
painted.
Laying conditions:
Must be dry with a minimum 10º C. Indoors, ventilation
and/or de-humidification may be necessary.
Surface finish:
Final colour coating squeegee applied. Play-lines
painted onto the surface.
* Please note the Surface pace can
be adapted to suit your requirements during the manufacturing
process.
Maintenance
Little maintenance required, although
the surface should be kept clean and free of dust
and debris. Washing the surface at least once a year,
or more regularly if required, is recommended.
|
