Centrecourt
Pro Acrylic Surface Systems
Centrecourt
pro Acrylic Crack & Leveling Compoud,
Product Specifications
Description
and Usage
Centrecourt Pro Acrylic Crack &
Levelling Compound is used to fill and level any surface
and structural cracks, as well as any birdbaths that
may have formed in the surface.
Application
Apply directly into clean, dry cracks
with a steel hand trowel.
For levelling ‘birdbaths’
use a rubber faced squeegee or straightedge.
Mix Design
| Centrecourt Pro Acrylic Crack and Levelling
Compound |
4 litres |
| 80 – 1—mesh, clean dry Silica
sand |
8 litres |
| Portland 1A Cement |
1 litre |
|
Blend the silica sand
with the cement in a clean mortar mixer or by use of
a hand drill. Add the Centrecourt Pro Acrylic Crack
and Levelling Compound while mixing. Mix until there
is uniform consistency. If the mix appears to dry, add
additional Centrecourt Pro Acrylic Crack and Levelling
Compound until a creamy consistency is obtained. Upon
completion of mixing apply to cracks or low areas immediately.
NEVER ADD WATER
Clean equipment and tools immediately
after completion.
Coverage
| Crack: |
1 litres of mixed emulsion. Approx. 64 –
80 centre metres measuring 0.63cm wide by
1.90cm to 2.54cm deep. |
| Patch: |
Quantities will vary with size and depth
of ‘birdbath’. |
|
Drying Time
Mixed material dries rapidly. Actual
drying time will vary according to width and depth of
crack or patch. Humidity, surface temperature and ambient
temperature will affect the drying process.
Limitations
and Precautions.
Centrecourt Pro Acrylic Crack and Levelling
Compound should not be applied when the ambient temperature
is below 100C (500F) or when the surface temperature
is above 600C (1400F). Do not store in direct sunlight.
Keep from freezing. Do not apply when rain is imminent.
back |
